Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Irvine, CA
Chimney repair in Irvine usually means working on factory-built metal flues, gas inserts, and the occasional 1970s masonry fireplace in older tracts like El Camino Real and the Ranch. Most Irvine homes were built after 1970 with wood-frame construction and stucco exteriors, so the repairs we do here rarely involve rebuilding brick stacks. Instead, we’re replacing rusted dampers, repairing chase covers, installing caps with spark arrestors, and relining metal flues that have corroded from years of coastal air. If you need an honest diagnosis of what’s actually wrong with your fireplace or venting system, call Acorn Chimney Sweep at (844) 510-0293.
Why Irvine Homes Are Different
Irvine is a master-planned city, and that shapes almost every chimney job we do here. The housing stock is dominated by tract homes and townhomes built between the 1970s and 2000s, with factory-built fireplaces seated in framed chases rather than traditional masonry chimneys. Woodbridge, Northwood, and Great Park lean heavily on pre-fab metal flue systems and direct-vent gas units. Older areas like El Camino Real and the Ranch still have original early-1970s masonry fireplaces, and those bring their own set of issues: hairline stucco cracks, rusted dampers, and water-stained smoke shelves that homeowners often never noticed because the fireplace hasn’t been lit in years.
Irvine’s HOA and city aesthetics rules add another layer. Exterior flue caps, spark arrestors, and chase covers usually have to match approved designs, so chimney work here frequently involves coordinating with HOA architectural guidelines before we install anything visible from the street. That’s not a hurdle for us, it’s just part of doing the job right in Irvine.
The climate matters too. Irvine’s mild, dry Mediterranean weather means wood-burning fireplaces are rarely used below 50°F, and most fires are decorative. Creosote buildup tends to be light compared to colder climates, but the long idle periods create their own problems: bird nests, debris, and moisture intrusion in caps and dampers. Santa Ana wind events drive fine dust and ash back down flues and can dislodge lightweight caps, so post-wind inspections are a regular part of our work here.
Styles & brands we work with
Our Main Irvine Services
Most Irvine homeowners call us for one of two things: a sweep and inspection of a fireplace that hasn’t been used in a while, or a dryer vent that’s been ignored for years. Both are core services for us, and both get the same camera-verified, no-guesswork treatment.
Chimney Sweep in Irvine
In Irvine, a chimney sweep usually means more than brushing out creosote. Because so many fireplaces here are factory-built or gas units, the job often involves inspecting the metal flue system, checking the damper, and making sure the cap and spark arrestor are intact. Long idle periods between uses mean we’re frequently pulling out bird nests, leaves, and the fine dust that Santa Ana winds push down the flue. If you haven’t used your fireplace in a season or longer, start with a sweep and inspection. Read more about what’s included on our Chimney Sweep in Irvine page.
Dryer Vent Cleaning in Irvine
Dryer vents in Irvine homes run through walls, floors, or ceiling chases, and lint accumulates in the same way it does everywhere else, which is to say, faster than most people think. In a wood-frame tract home, a clogged dryer vent is a genuine fire risk that hides behind the wall until something goes wrong. We clean the full run from dryer to exterior termination, clear blockages, check the exterior vent flap, and show you the before-and-after photos so you can see exactly what we removed. Details are on our Dryer Vent Cleaning in Irvine page.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Irvine
Chimney repair in Irvine is less about rebuilding masonry and more about addressing what time, coastal air, and disuse do to metal components and flue systems. In older tracts like the Ranch and El Camino Real, we regularly find rusted dampers and water-stained smoke shelves in fireplaces that haven’t been lit in years. In newer villages, the issue is usually a corroded pre-fab flue, a failed chase cover, or a cap that’s gone missing after a Santa Ana wind event. Acorn Chimney Sweep has served Irvine since 2015, and we diagnose every repair with camera evidence before recommending any work, which means you see exactly what we see. For a deeper look at how we approach repairs, see our Chimney Repair hub.
Chimney Cap Installation
Signs you need it
You can see daylight through the top of your flue, or water is getting in during Irvine’s rare winter storms and staining the firebox or ceiling below.
What it costs in Irvine
Chimney cap installation in Irvine typically runs $220 to $650 depending on the flue size, cap material, and whether a custom spark arrestor is needed to satisfy HOA design rules.
How we do it
We measure the flue, check the HOA-approved or code-required cap profile, install the cap with a proper spark arrestor, and seal the attachment so wind and rain stay out.
Chimney Liner Installation
Signs you need it
The existing flue shows visible corrosion, cracking, or gaps during a camera inspection, or the fireplace vents poorly and you’re getting smoke or odor inside the home.
What it costs in Irvine
Liner installation in Irvine typically runs $2,600 to $6,400 depending on flue height, liner diameter, and whether we’re relining a pre-fab metal flue or a masonry chimney in an older Ranch-area home.
How we do it
We inspect the existing flue with a camera, size the new liner to the appliance and flue dimensions, install a DuraFlex flexible liner system or resurface with HeatShield, and verify the connection at the appliance and cap.
Chimney Flashing Repair
Signs you need it
Water stains appear on the ceiling near the chimney, or the flashing at the roofline shows visible gaps, lifted seams, or dried-out sealant around the penetration.
What it costs in Irvine
Flashing repair in Irvine typically runs $400 to $1,500 depending on the roof pitch, the extent of the damaged flashing, and whether we’re also replacing a rusted chase-top pan above it.
How we do it
We remove the old flashing, inspect the underlayment and surrounding roof deck, install new flashing with proper step and counterflashing, and seal every seam so rain from Irvine’s winter storms can’t track inside.
Chimney Crown Repair
Signs you need it
The concrete crown on an older masonry chimney shows hairline cracks, spalling, or sections that have broken away entirely, letting water seep into the masonry below.
What it costs in Irvine
Crown repair in Irvine typically runs $650 to $1,800 depending on crown size, crack depth, and whether we’re resurfacing the existing crown or pouring a new one with proper overhang and drip edge.
How we do it
We clean the crown surface, fill or remove damaged material, and rebuild or resurface it so water sheds away from the flue instead of soaking into the masonry and slowly destroying the chimney from the inside.
What Chimney Repair Costs in Irvine
| Item | Typical range in Irvine |
|---|---|
| Chimney cap installation | $220 – $650 |
| Chimney liner installation | $2,600 – $6,400 |
| Chimney flashing repair | $400 – $1,500 |
How do I know if my Irvine fireplace actually needs repair?
You don’t, until someone looks at it with a camera. In Irvine, most fireplaces sit unused for months, so damage accumulates quietly: rusted dampers, corroded flue liners, cracked crowns. We don’t recommend any repair without showing you the camera evidence first. Call us for an inspection.
Can I wait until winter to fix my Irvine chimney?
Usually, yes, but waiting on water-related damage makes the repair worse. Irvine’s Santa Ana winds and rare winter storms push dust, debris, and moisture into openings that aren’t sealed. If you see water stains or rust, address it now, before the next rain season. Call for an exact assessment.
Brands We Service in Irvine
We stock and install components from professional-grade brands including Gelco, Olympia Chimney, Famco, and Copperfield. These are the same cap, cover, and chimney component lines certified professionals specify, not hardware-store substitutes. Most common repair parts are on our trucks, which means we can complete many Irvine repairs in a single visit. See our brands for more detail.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Irvine, CA
| Service | Typical range in Irvine |
|---|---|
| Chimney sweep (pre-fab or gas fireplace) | $175 – $300 |
| Chimney sweep with full camera inspection | $300 – $450 |
| Chimney cap installation | $220 – $650 |
| Chimney cap replacement | $300 – $750 |
| Chimney liner installation | $2,600 – $6,400 |
| Chimney flashing repair | $400 – $1,500 |
| Chimney crown repair | $650 – $1,800 |
| Dryer vent cleaning (standard single run) | $130 – $250 |
| Dryer vent cleaning (long or multi-story run) | $250 – $450 |
In Irvine, prices can push toward the upper end when an HOA requires a specific cap or spark arrestor profile, when access requires working around a tile roof or steep pitch common to some tract homes, or when we’re relining a flue in an older masonry chimney with hidden water damage. Every estimate is a flat price agreed before we start, and nothing gets recommended without camera evidence you can see for yourself.
Neighborhoods We Serve in Irvine
We cover every ZIP code in Irvine: 92617, 92618, 92619, and 92620. Most of our work takes us into the villages and older tracts alike, and we’re familiar with the HOA quirks and construction details in each.
- Woodbridge
- Northwood
- Great Park
- El Camino Real
- The Ranch
Typical response time for the Irvine area is one to three business days depending on the season, with post-Santa Ana wind checks getting priority when damage is weather-related.
Service Area – Cities Near Irvine
Acorn Chimney Sweep also serves the surrounding South Orange County communities. If you’re in Aliso Viejo, CA, San Joaquin Hills, CA, Laguna Woods, CA, or Costa Mesa, CA, we can handle your chimney, liner, cap, or dryer vent work with the same camera-verified approach. Call us and we’ll confirm coverage for your address.
Serving Irvine, CA — Our Local Coverage Area
We’re based in the Irvine area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Irvine
Most Irvine appointments are scheduled within one to three business days. If you just came through a Santa Ana wind event and suspect cap damage or debris in the flue, let us know when you call and we’ll do our best to prioritize it. For exact availability, call (844) 510-0293.
Often, yes. Irvine has strict city and HOA aesthetics rules, and exterior components like flue caps, spark arrestors, and chase covers usually have to match approved designs. We’re used to coordinating with architectural guidelines and can help you navigate what your specific HOA requires before we install anything visible from the street.
Yes. We work across all four Irvine ZIP codes: 92617, 92618, 92619, and 92620. Whether you’re in a 1970s masonry fireplace home in El Camino Real or a newer direct-vent gas fireplace in Great Park, the inspection and repair approach is the same: camera evidence first, no guesswork, no unnecessary work.
If you need chimney sweeping, chimney repair, or dryer vent cleaning in Irvine, call Acorn Chimney Sweep at (844) 510-0293 for a free estimate. We’ll tell you plainly what needs doing, what can wait, and what it costs before any work begins.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Irvine Customers Say
"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
— Grace Wong"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
— Lucia Ramirez"Crown was cracked and taking water. Repaired it rather than quoting a rebuild, which the previous company had pushed hard for."
— Diego Reyes