Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Dryer Vent Cleaning Across Murrieta
Dryer vent cleaning in Murrieta typically costs $135 – $225 for a standard single-story run and takes about 60 to 90 minutes from setup to final airflow test. Most homes in the 92562, 92563, and 92564 ZIP codes have vents we can service same-week, and we carry rigid metal replacement sections on the truck so we’re not making a second trip when we find crushed foil-flex. If you live off Clinton Keith Road, California Oaks Road, or near the older tracts around Murrieta Hot Springs, you’re dealing with the exact housing stock we know best: 1980s-2000s tract homes where dryer ducts hide inside walls, chases, and attics, and nobody has looked at them since move-in. Call (844) 510-0293 and we’ll give you a straight answer on whether you actually need a cleaning or can safely wait.
Why Acorn Chimney Sweep Is Murrieta’s Preferred Dryer Vent Cleaning Company
Acorn Chimney Sweep comes to Murrieta as a full-system venting specialist. That matters here because Murrieta’s housing stock doesn’t separate neatly into “chimney problems” and “dryer vent problems.” A 1990s tract home in 92562 often has a dryer duct running through the same chase as the fireplace flue, and lint buildup in that shared space is a fire load sitting right next to a heat source. We see it weekly. Our Dryer Vent Cleaning team runs camera inspections on every visit, not just at the end, so you see the blockage before anyone quotes you a repair. Noel Cardenas built the company around that approach: show the homeowner evidence, then fix what the evidence shows. No camera, no recommendation.
Murrieta homeowners call us because we don’t upsell from a two-page checklist. When we find a vent that’s actually clean, we say so. When we find a torn foil-flex liner in a Cal Oaks Road home that’s been trapping lint for a decade, we show the footage, explain the repair, and do it with professional-grade components from brands like Copperfield and Olympia Chimney. One truck, one appointment, one company accountable for the whole system.
Styles & brands we work with
Our Dryer Vent Cleaning Services in Murrieta
Full Dryer Vent Cleaning and Airflow Testing
We clean the entire run, not just the first three feet behind the dryer. That means the wall penetration, the elbow sections, and the termination at the roof or eave. In Murrieta’s 92562 and 92563 homes, termination points are often roof caps that haven’t been touched since the house was built, and we routinely find them packed with wind-driven sand and lint from Santa Ana season. After cleaning, we test airflow with a digital manometer and show you the before-and-after numbers. A healthy vent moves air at 14 – 18 mph at the exterior cap; we’ve seen Murrieta vents moving under 4 mph.
Camera Inspection with Photo Report
Every cleaning includes a camera inspection of the full duct run, and you get the photos. That’s not an add-on, it’s the job. In older 92562 tracts, dryer ducts often run 15 – 25 feet through walls and chases, and the only way to know what’s actually inside is to look. We find collapsed foil-flex, disconnected joints, and rodent nests that are invisible from the laundry room. You see everything we see, on the spot, before you spend a dollar on anything beyond the cleaning itself.
Foil-Flex Duct Replacement with Rigid Metal
Murrieta’s 1980s and 1990s tract builders used foil-flex dryer duct extensively. It’s cheap, it kinks, and it tears. The sagging loops collect lint and sand until the vent is effectively closed. We replace this with rigid galvanized metal duct, cut to length, sealed with foil tape (never screws, which catch lint), and secured with proper support. For Murrieta homes where the dryer sits against an exterior wall, this is usually a 30-minute fix. For longer interior runs, we’ll show you the route and the cost before any material gets cut.
Roof and Exterior Cap Cleaning and Replacement
A dryer vent cap with a stuck flapper or a bird guard clogged with lint doesn’t just reduce airflow, it invites pests back into the duct. We clean or replace caps on every visit, using components from Famco and Copperfield. In Murrieta’s dry climate, roof caps also collect an unusual amount of wind-blown debris, especially in the 92563 neighborhoods that sit open to the Santa Anas. A new cap with a proper damper stops lint from entering the pipe from the outside and keeps the vent working between cleanings.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Murrieta
We stock and install components from brands certified chimney and venting professionals actually specify. For dryer vent work, that means termination caps, wall thimbles, and rigid duct sections from Copperfield and Famco, two lines built to handle real heat and real airflow, not the stamped white boxes at the hardware store. For the chimney side of your system, we carry Olympia Chimney and other professional lines. When we’re in Murrieta and find a damaged cap or a rusted wall termination, we fix it that day with parts off the truck, not a promise to come back in two weeks. You get the same components a licensed specialist would put on any home in Temecula or Wildomar, priced at Murrieta market rates with zero markup games.
See the difference
Before
After
Before
After
Before
AfterCommon Dryer Vent Cleaning Problems We See in Murrieta Homes
- Crushed foil-flex behind the dryer. The original 1980s and 1990s duct gets pushed back against the wall during a remodel or appliance swap, kinks, and halves the airflow. The lint screen looks clean, so nobody suspects it. We find this in roughly half of Murrieta’s older homes on first visit.
- Sagging duct runs inside walls and chases. Foil-flex installed across a 15-foot span without support loops down and collects a wet lint mass. In Murrieta’s dry season this cures into a dense plug. Airflow drops, the dryer runs longer, and the heating elements cycle hot. This is the setup we see most in 92562 tracts from the 1980s and early 1990s.
- Roof caps packed with wind-blown sand and lint. The Santa Ana winds push dry debris straight into poorly capped terminations, especially in the exposed neighborhoods of 92563. We clean these out and replace the cap with a proper damper model so it stops happening.
- Dryer vents terminated into shared chimney chases. Some Murrieta builders ran laundry exhaust through the same chase as the fireplace flue. Lint accumulates in the chase cavity, within a few feet of a heat source. This is the single most dangerous configuration we inspect, and it demands camera evidence and often a re-route to an exterior wall. We show you the footage and lay out the options plainly.
Pricing for Dryer Vent Cleaning in Murrieta, CA
A standard dryer vent cleaning in Murrieta runs $135 – $225 depending on the length of the duct run and the roof access. Single-story homes with a short exterior wall termination fall at the lower end. Two-story homes or runs over 15 feet, especially those that terminate on a steep roof, land at the upper end. If we find damaged duct that needs replacement, rigid metal sections add $45 – $95 depending on length and access. A new exterior cap runs $30 – $60. The camera inspection and photo report are included in the cleaning price, not billed separately. You’ll get a firm quote before any work starts, and if the vent is clean, we tell you that and charge the inspection rate only. Call (844) 510-0293 for an exact quote on your Murrieta home.
We Also Serve Cities Near Murrieta
Our trucks cover Murrieta Hot Springs, Wildomar, Temecula, and the Sedco Hills area regularly, often same-week. If you’re in one of those communities and your dryer takes two cycles to finish a load, the vent is the first thing to check. We bring the same camera inspection and rigid metal upgrades to every job, whether it’s a 1980s tract home in Murrieta or a newer direct-vent build in Temecula. Same truck, same standards, same phone number: (844) 510-0293.
Serving Murrieta, CA — Our Local Coverage Area
We’re based in the Murrieta area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Dryer Vent Cleaning in Murrieta
The most common cause in newer 92563 homes is a long, convoluted foil-flex duct run that sags inside the wall or attic, not a dirty lint screen. Builders in these developments often ran flexible duct 20 feet or more to reach an exterior wall, and over a few years that material kinks and traps lint. We confirm it with a camera inspection and show you the exact restriction. If the duct routing is the issue, replacing the flex with rigid metal restores dry times to one cycle. Call (844) 510-0293 and we’ll inspect it the same week.
Every 12 to 18 months for homes in 92562 and 92563, and closer to 12 months if you have a long foil-flex run or a roof termination exposed to Santa Ana winds. The dry climate doesn’t make lint accumulate faster on its own, but it does make any blockage more dangerous because the lint is bone-dry and ignites more easily. Wind-blown sand adds to the load. Homes with short, rigid metal runs and direct exterior terminations can go 24 months, but we recommend an annual airflow check either way.
No, not as originally built. Routing a dryer exhaust through the same cavity as a fireplace flue places combustible lint within a few feet of a heat source, and it violates the fire-blocking intent of modern building codes. We see this in 92562 homes from the 1980s and early 1990s more than anywhere else in the Temecula Valley. The fix is re-routing the dryer vent to an exterior wall with rigid metal duct, and we’ll show you camera footage of the current configuration before we recommend anything. The repair is straightforward and usually takes under a day. Call (844) 510-0293 for an assessment.
Yes, they’re separate systems with separate risks. Dryer vent cleaning removes lint from the duct that carries hot, moist exhaust out of your laundry room. Chimney cleaning removes creosote and soot from the flue that vents your fireplace or stove. In Murrieta homes where both exist in the same chase, a problem in one directly affects the safety of the other. Our crews do both, which means one appointment can cover the entire venting system, and you get one honest report with camera evidence for both. Call (844) 510-0293 to schedule a combined inspection.
Yes, and this is the exact scenario that makes Murrieta’s older homes concerning. The dryer keeps running, the lint screen catches the visible fuzz, and the heating element cycles a little longer each month. Meanwhile the hidden duct is filling with lint and, in Murrieta’s windy season, sand. The first sign is often a longer dry time, not a dramatic failure. By the time the dryer shuts down or a burning smell appears, the vent has been a fire load for months. In the Cal Oaks area of 92562, we recently serviced a 1990s tract home where the homeowner had never cleaned the dryer vent since purchase. Our tech found the original foil-flex duct crushed behind the dryer, packed with a dense lint-and-sand mixture typical of Murrieta’s windy season. After replacing the transition with a short rigid metal section and clearing the full run, airflow jumped from a weak trickle to a strong exhaust, and we showed the homeowner before-and-after camera footage of the lint clog before recommending anything. That’s the standard: evidence first, fix second. Call (844) 510-0293 if your dryer has been getting slower or the exterior flap barely moves when it runs.
Written by Noel Cardenas, Owner at Acorn Chimney Sweep, serving Murrieta and the surrounding Temecula Valley communities with dryer vent cleaning, chimney sweeping, and repair.